Clive W. Humphris

**DC VOLTAGE: Voltage Divider. **

A simple voltage divider circuit can be constructed as shown, using just two resistors connected across a voltage supply.

Current I will flow through R1 and R2 determined by their combined value. The lower voltage (Vout) across R2 is found by Ohm's Law I × R2.

Circuits connected to the Vout junction are referred to as the Load. Load current will flow through R1 in addition to R2 current and effectively pull down the voltage at this junction due to the increased voltage drop across R1.

- Table of Contents
- Interactive eTextbooks
- Basic Electronics
- Conductor And Insulator
- Resistor Value Test
- Simple Dc Circuits
- Types Of Switching
- Variable Voltages
- Ohm's Law
- DC Voltage
- DC Current
- Series and Parallel Resistors
- AC Measurement
- AC Voltage and Current
- AC Theory
- RCL Series
- RCL Parallel
- Capacitance
- Capacitors
- Inductance
- Inductors
- Impedance
- Radio and Communication
- Tuned Circuits
- Attenuators
- Passive Filters
- Active Filters
- Oscillators
- Circuit Theorems
- Complex Numbers
- DC Power
- AC Power
- Silicon Controlled Rectifier
- Power Supply
- Voltage Regulation
- Electro-Magnetism
- Electrical Machines
- Transformers
- Three Phase Systems
- Energy Transfer and Cost
- Atomic Structures
- Diode Theory
- Diode Applications
- Transistor Theory
- Bipolar Transistors
- Transistor Configurations
- Active Transistor Circuits
- Field Effect Transistors
- Basic Operational Amplifier
- Op-Amp Theory
- Op-Amp Applications
- Sum and Difference Amplifiers
- Analogue Multi-Meter
- Component Testing